Visual Land Impulse Guía para resolver problemas descargar pdf (Pagina 20)

ImPulse

™

Elite Patient Manual

Problem Possible Cause Solution

No battery in unit, or

battery requires replace-

ment.

Battery not inserted

correctly.

Battery may be dis-

charged.

Brass/CGA sealing washer

is missing from unit.

Worn brass/CGA sealing

washer.

Unit not properly secured

to cylinder, or securing

knob not tight.

PULSE FLOW/CONTINUOUS

FLOW switch in CONTINU-

OUS FLOW position.

Cannula tubing is kinked or

not properly adjusted.

ON/OFF power switch set

to OFF position.

Oxygen cylinder is empty.

Oxygen cylinder valve is

closed.

If your unit fails to operate as described in this manual, first review the following

chart for possible causes and solutions. If necessary, contact your Equipment

Provider.

Troubleshooting Guide

Power switch ON

but no lights

display.

Intermittent power,

intermittent

pulsing, lights flash,

alarm sounds.

Oxygen leaks from

unit.

Constant flow of

oxygen from unit.

Unit does not

deliver oxygen.

Any other unit

problem.

Replace battery.

Insert battery properly by

referencing polarity guide on

inside of battery compartment

door.

Replace Alkaline battery with

new D-cell Energizer battery.

Ensure that the brass/CGA

sealing washer is present at the

oxygen cylinder connection on

the unit.

Replace brass/CGA sealing

washer.

Close cylinder valve and verify

that the unit alignment pins are

correctly fitted to the cylinder

alignment holes and that the

securing knob is tight.

Position switch to PULSE FLOW

position.

Check or replace tubing as

necessary.

Set ON/OFF power switch to ON

position.

Replace cylinder.

Open cylinder valve a minimum

of one turn counterclockwise.

Contact your Equipment

Provider.

1 2 ... 15 16 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios

Visual Land Impulse Guía para resolver problemas Pagina 20

Comentarios a estos manuales