Visual Land Impulse Instrucciones de operaciones descargar pdf (Pagina 18)

OPERATING TIPS

1. Keep the search coil cable wound snugly around

the stem when diving around coral or jagged rocks

to keep it from snagging.

2. Divers should make sure the drain holes in the

headset are unobstructed. Better yet, wait until

you’re on the bottom before putting your headset

on, and take it off before surfacing.

3. Divers should also keep the search coil at least 2

feet away from their bodies. Metal gear (weights,

gauges, tanks, etc.) will be detected by the

IMPULSE if held too close.

4. Practice pinpointing. There’s nothing sacred

about the method described in this manual. Many

IMPULSE users have developed their own

pinpointing methods.

5. If you’re wading or hunting on land, hold your

digging tool behind your back or above your waist.

Your IMPULSE is sensitive enough to sound off each

time the coil gets near it.

6. Don’t waste a lot of time digging holes for targets

you can’t find. If your hole keeps getting deeper and

wider, cover it up and go on. You may be over a buried

pipe or some other large, deep target. (However, if

you’re looking for a deep target, keep digging.)

7. If you’re looking for large, shallow targets,

detune your IMPULSE slightly below threshold. You’ll

pass right over a lot of small trash this way, but you

won’t miss items capable of producing a strong

target signal.

8. Good things often come in two’s or even three’s.

Once you’ve recovered a good target, always

recheck the hole for a second signal and carefully

search the immediate area by searching slowly

around the hole two or three times, slowly

increasing your search area. Always dig every

suspicious sound in the vicinity of a good find.

9. Recheck your hole even if your find was trash.

Good targets are often found beneath bad ones.

10. Practice. Practice over known targets. Practice

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Sin comentarios

Visual Land Impulse Instrucciones de operaciones Pagina 18